TM 5-4320-300-144-7. SETUP INSTRUCTIONSa. Locate unit as level as possible.b. Locate unit to keep suction and discharge lines as short and straight as possible.c. Position trailer at site in proper position for pumping and place chock blocks under trailer wheels to prevent rolling.d. Pull out on lock pin and pull down the front leg assembly until it locks.e. Free lock pins in rear stand assemblies.WARNINGLower and pin the rear stands before disconnecting centrifugal pump unitfrom towing vehicle. Unit could drop on rear bumper and cause personalinjury.CAUTIONRemove and insert pin from rear stand assemblies with the handle end ofthe pin facing upward. The pin locking mechanism will stick within therear stand if pin is inserted and removed any other way.f. Lower rear stand assemblies, install lock pins in holes so that the leg assemblies hold the trailer as level as possible.g. Disconnect safety chains and intervehicle connector. Uncouple coupling and rest centrifugal pump unit on front legassembly.h. Relower rear stand assemblies to lowest point.i. Remove discharge port and suction port protective plugs. Connect discharge and suction lines.4-6
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
