TM 5-4320-234-20P
Explanation
Items with these codes are not to be requested/requisitioned
individually. The parts that make up the assembled item must be
requisitioned or fabricated and assembled at the level of maintenance
indicated by the source code. If the 3d position code of the SMR code
authorizes you to replace the item, but the source code indicates the
items are assembled at a higher level, order the item from the higher
level of maintenance.
Code
Explanation
XA -- Do not requisition “XA" -coded item. Order its next higher assembly. (Also, refer to the NOTE below.)
XB -- If an "XB" item is not available from salvage, order it using the FSCM and part number given.
XC -- Installation drawing, diagram, instruction sheet, field service drawing, that is identified by manufacturer's
part number.
XD -- Item is not stocked. Order an “XD”--coded item through normal supply channels using the FSCM and
part number given, if no NSN is available.
NOTE
Cannibalization or controlled exchange, when authorized, may be used as a source of supply for
items with the above source codes, except for those source coded "XA" or those aircraft support
items restricted by requirements of AR 750-1.
(2)
Maintenance Code. Maintenance codes tells you the level(s) of maintenance authorized to USE
and REPAIR support items. The maintenance codes are entered in the third and fourth positions of
the SMR code as follows:
(a)
The maintenance code entered in the third position tells you the lowest maintenance level
authorized to remove, replace, and use an item. The maintenance code entered in the third
position will indicate authorization to one of the following levels of maintenance.
Code
Application/Explanation
C--Crew or operator maintenance done within organizational or aviation unit maintenance.
O--Organizational or aviation unit category can remove, replace, and use the item.
AO-
(Assembled by
org/AVUM Level)
AF-
(Assembled by
DS/AVIM Level)
AH-
(Assembled by GS
Category)
AL-
(Assembled by SRA)
AD-
(Assembled by Depot)
3
