TM 5-4320-234-20P
(4) FIG. column. This column lists the number of the figure where the item is identified/located in-
Sections II and III .
(5) ITEM column. The item number is that number assigned to the item as it appears in the figure
referenced in adjacent figure number column.
c. FIGURE AND ITEM NUMBER INDEX.
(1) FIG. column. This column lists the number of the figure where the item is identified/located in
Section II and III .
(2) ITEM column. The item number is that number assigned to the item as it appears in the figure
referenced in the adjacent figure number column.
(3) STOCK NUMBER column. This column lists the NSN for the item.
(4) FSCM column. The Federal Supply Code for Manufacturer (FSCM) is a 5-digit numeric code used
to identify the manufacturer, distributor, or Government agency, etc., that supplies the item.
(5) PART NUMBER column. Indicates the primary number used by the manufacturer (individual, firm,
corporation, or Government activity), which controls the design and characteristics of the item by
means of its engineering drawings, specifications standards, and inspection requirements to identify
an item or range of items.
5. SPECIAL INFORMATION.
a. USABLE ON CODE. The usable on code appears in the lower left corner of the Description column
heading. Usable on codes are shown as "UOC: ........... " in the Description Column (justified left) on the last
line applicable item description/nomenclature. Uncoded items are applicable to all models.
b. ASSOCIATED PUBLICATIONS. The publications listed below pertains to the Pumping Assembly
(Model US90CCG-1) and its components.
Publication
Short Title
LO 5-4320-234-12
Pump, Centrifugal, Self-Priming
TM 5-4320-234-12
Pump, Centrifugal, Self-Priming
TM 5-4320-234-34
Pump, Centrifugal, Self-Priming
TM 5-4320-234-34P
Pump, Centrifugal, Self-Priming
c. TM CLARIFICATION. The illustrations in this manual are identical to those published in TM 5 4320-234-
34P. Only those parts assigned the third position SMR maintenance code "C" or "O" are listed in the tabular
listing; therefore, there may be a break in the item number sequence. Only illustrations containing organiza-
tional authorized items appear in this manual.
6. HOW TO LOCATE REPAIR PARTS.
a. When National Stock Number or Part Number Is NOT known.
(1) First. Using the table of contents, determine the assembly group or subassembly group to which the
item belongs. This is necessary since figures are prepared for assembly groups and subassembly
groups, and listings are divided into the same groups.
7
