TM 10-4930-236-13&PB-2.MAINTENANCE FUNCTIONS - Continuedi.Repair. The application of maintenance services' or other maintenanceactions2 to restore serviceability to anitem by correcting specific damage, fault, malfunction, or failure in a part, subassembly, module (component orassembly), end item, or system.j.Overhaul. That maintenance effort (service/action) necessary to restore an item to a completelyserviceable/operational condition as prescribed by maintenance standards in appropriate technical publications i.e.,DMWR). Overhaul is normally the highest degree of maintenance performed by the Army. Overhaul does not normallyreturn an item to like new condition.k.Rebuild. Consists of those services/actions necessary for the restoration of unserviceable equipment to a likenew condition in accordance with original manufacturing standards. Rebuild is the highest degree of materialmaintenance applied to Army equipment. The rebuild operation includes the act of returning to zero those agemeasurements (hour/miles, etc.) considered in classifying Army equipment components.B-3.EXPLANATION OF COLUMNS IN THE MAC, SECTION IIa.Column 1, Group Number. Column 1 lists functional group code numbers, the purpose of which isto identifycomponents, assemblies, subassemblies, and modules with the next higher assembly.b.Column 2, Component/Assembly. Column 2 contains the names of components, assemblies, subassemblies,and modules for which maintenance is authorized.c.Column 3, Maintenance Function. Column 3 lists the functions to be performed on the item listed in Column 2.(For detailed explanation of these functions, see paragraph B-2).d.Column 4, Maintenance Category. Column 4 specifies, by the listing of a work time figure in the appropriatesubcolumn(s), the category of maintenance authorized to perform the function listed in Column 3. This figure representsthe active time required to perform that maintenance function at the indicated category of maintenance. If the number orcomplexity of the tasks within the listed maintenance function vary at different maintenance categories, appropriate worktime figures will be shown for each category. The work time figure represents the average time required to restore anitem (assembly, subassembly, component, module, end item, or system) to a serviceable condition under typical fieldoperating conditions. This time includes preparation time (including any necessary disassembly/assembly time),troubleshooting time, and quality assurance/quality control time in addition to the time required to perform the specifictasks identified for the maintenance functions authorized in the maintenance allocation chart. The symbol designationsfor the various maintenance categories are as follows:'C ............................................Operator or crew.O .......................... Organizational maintenance.F ........................... Direct support maintenance.H ........................ General support maintenance.D ........................................Depot maintenance.e.Column 5, Tools and Equipment. Column 5 specifies, by code, those common tool sets (not individualtools) and special tools, TMDE, and support equipment required to perform the designated function.f.Column 6, Remarks. This column shall, when applicable, contain a letter code, in alphabetical order,which shall be keyed to the remarks contained in Section IV.1Services - inspect, test, service, adjust, aline, calibrate, or replace.2Actions - welding, grinding, riveting, straightening, facing, remachining, or resurfacing.B-2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business