TM 10-4930-204-13
2-4. OPERATION.
The tank and pump unit is intended for use in dispensing all types of automotive, aviation, diesel and burner fuels.
Only one type of fuel should be carried in and dispensed from the unit at one time. Since the pumping assembly is
highly adaptable, dispensing with the tank and pump unit may be done in various ways to meet different situations
in the field. Most of the differences between the models covered in this manual have no direct effect on the basic
operational function.
2-5. STOPPING.
a. Stopping Procedures for Engine. Refer to figure 2-9 and stop the engine in accordance with the procedures.
b. Stopping Procedure for Electric Motor Driven Pumping Assembly.
(1)
2-8).
(2)
To stop the electric motor driven pumping assembly, turn the remote pump switch to its OFF position (fig.
Reduce hand throttle setting to idle.
c. When moving to a new location:
(1) Disconnect ON-OFF switch cable from junction box receptacle J1. (figure 1-4.1)
(2) Disconnect intervehicular power cable from vehicle receptacle and junction box receptacle J2.
Change 4
2-7
