TM 10-4630-207-13&P
0050 00
WARNING
The engine/vacuum pump skid is heavy. To prevent injuries, never stand or
reach under a suspended skid. Ensure lifting equipment is of adequate
capacity (2,000 pounds) and operator is trained and approved to operate the
equipment. Have dunnage ready and in position to set the skid onto.
14. Lift engine/vacuum pump skid (figure 5, item 1) off the trailer frame and set it upon dunnage (figure 5,
item 2) (preferably lengths of 2-inch x 4-inch lumber).
2
1
2
Figure 5. Setting Skid onto Dunnage
15. Remove the pulley guard from the skid as described in steps 2., and 3., of WP 0044 00.
16. Loosen the vacuum pump outside mounting bolts and flat washers (figure 6, item 1). Retain bolts and
washers.
WARNING
The vacuum pump inside mounting bolts are located in a restricted space.
Exercise caution and wear gloves when loosening and tightening these bolts
to avoid injuries due to pinching.
17. Loosen the vacuum pump inside mounting bolts and flat washers (figure 6, item 2). Retain bolts and
washers.
0050 00-4
