TM 10-4630-206-12&P
0017 00
4. Replace a heater element that shows continuity between any heater lead and ground.
NOTE
The test described in steps 5. and 6. cannot be performed on the Waste
Water Evacuation SEP (9-1-0527).
5. Using a multimeter (3) set to read resistance (ohms Ω), check for continuity between the two heater
wires. There should be continuity (9-1-0150-1 and 9-1-0150-2 only).
6. If there is a reading of zero (0) or infinity (Q), replace heater element. (9-1-0150-1 and 9-1-0150-2
only).
7. Replace an inoperative heater element (9-1-0527).
3
1
2
0017 00-2
