PROCEDURES: 1. 2. 3. 4. 5. 6. 7. 8. Refer   to   appendix   F,   Figure   F-3,   and   using   a   multimeter,   determine   which wire   is   defective. If   defective   wire   is   soldered,   desolder   wire   from   connector. Remove   defective   wire   from   wiring   harness. Refer   to   table   D-6   and   cut   wire   from   bulk. Wire   assembly   numbers   in   table D–6   are   for   information   only,   they   are   not   marked   on   wiring   harness,   refer to   terminations   to   determine   what   components   comprise  damaged   wire. Strip   approximately   0.250   (0.635   cm)   inch   of   insulation   from   each   end   of w i r e. Crimp   or   solder   terminal(s)   to   wire. For   all   soldered   assemblies   install   heat-shrink   tubing   over   solder connections. a . For   all   wire   assembly   numbers   in   table   D-7,   noted   with   a   ¹   use   heat- shrink   tubing   18763-249. b . For   all   wire   assembly   numbers   in   table   D-7,   noted   with   a   ²   use   heat- shrink  tubing  part  number  18763-248. Install   repaired   wire   in   wiring   harness. Table   D-6.   Parts   List   for   Main   Wiring   Harness,   Model   609-C. Find Part   or Quantity Description NSN Number Identifying   Number Required 1 27213-028 5 Lug,  Terminal 2 27216-565 3 Lug,  Terminal 3 27214-528 2 Terminal 4 27214-527 1 Terminal 5 27214-525 1 Terminal 6 27228-515 7 Socket,   Connector 7 27216-576 3 Lug,   Terminal 8 27216-564 1 Lug,  Terminal 9 27214-527 2 Terminal 10 27284-202 6 Splice,   Wire 11 27214-516 2 Terminal 12 27214-515 4 Terminal 13 27215-322 1 Terminal 14 27215-313 1 Terminal 15 27214-527 1 Terminal 16 27228-505 11 Connector,   Pin 17 1 S t r ip 18 29331-941 1 Pigtail,    Voltage, Regulator D-11 TM 10-4320-344-24