2.21.31 OilBreatherAssemblyReplacement,Models609-CandUS636HCCD-1.(Continued)This procedure applies to Model US636HCCD-1.The procedure for Model 609-ci s s i m i l a r .2.21.31.1 Removal.a .Remove bolt (Figure 2-146, 1), lock washer (2), hose retainer (3), and spacer(4) from engine (5).Discard lock washer (2).b .Remove bolt (6), lock washer (7), flat washer (8), oil breather (9), andretainer bracket (10) from engine (5).Discard lock washer (7).c .Loosen hose clamp (11) and remove hose clamp (11) and hose (12) from oilbreather (9).2.21.31.2 Repair.a .Inspect all components and mounting hardware for damage.b .Replace all defective components.2.21.31.3 Installation.a .Install hose (12) on oil breather (9) and secure with hose clamp (11).b .Position retainer bracket (10) and oil breather (9) against engine (5) andsecure with flat washer (8), new lock washer (7), and bolt (6).c .Slide hose retainer (3) over hose (12), position against engine (5) and securewith spacer (4), new lock washer (2), and bolt (1).2-332TM 10-4320-344-24
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business