TM 10-4320-344-242.16.12 Meter Assembly Maintenance.This task c o v e r s:2.16.12.1 Removal2 .16 .1 2 . 3 I n s t a l l a t i o n2 .16 .1 2 . 2 R e p a irINITIALSETUPToolsGeneral Mechanic’s AutomotiveTool Kit, Appendix B, SectionI I I,Item 1Material/PartsT a gs( Appendix C, Item 31Lock Washers (TM 10-4320-344-24P)Equipment ConditionsPumping station shut down, TM10-4320-344-10.Battery disconnected, paragraph2.15.2 (609-A), 2.15.3 (609-C), and 2-15-4 (US636HCCD-1)Equipment Conditions (Continued)Control Panel Door open, Model 609-C.Control Panel Cover Assembly removed,paragraph 2.16.1 (609-A) or 2.16.2(US636HCCD-1).General Safety InstructionsTo prevent rolling or sliding, do not workon equipment that is not securelys t a b i l i z e d.Do not work on equipment with batteryconnected.Electrocution hazard ispresent if battery is connected.Do not work on equipment without followingstandard shop safety precautions.•This is a general maintenance procedure for meter assemblies.Thisprocedure applies to the following meter assemblies:Ammeter Assembly (Models 609-A and US636HCCD-1)Engine Temperature Gauge Assembly (Model 609-C)Hourmeter Assembly (Model 609-C)Oil Pressure Gauge Assembly (Model 609-C)Tachometer Assembly (609-C)Voltmeter (Model 609-C)•All meter assemblies are identified on the control panel forpumping assembly.For further information on meter assemblylocations reference TM 10-4320-344-10.2.16.12.1 Removal.eachDo not work on equipment with battery connected.Electrocution hazard ispresent if battery is connected.Failure to obey this warning may result indeath or serious personal injury.a .Remove two nuts (Figure 2-63, 1).b .Tag and remove wires (2) from meter or gauge assembly (3).c .Remove two nuts (4), lock washers (5), bracket (6), and meter or gaugeassembly (3).Discard lock washers (5).2-167
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
