TM 10-4320-325-14
REMOVAL/INSTALLATION
NOTE
Once the equipment has been prepared to the equipment condition requirements, no
further removal/installation procedure Is required.
INSPECTION Refer to Figure 6-26
a. Clean crankcase with diesel fuel and a wire brush to remove carbon or oil deposits Wash thoroughly with live
steam and dry with compressed air
b. Inspect cylinder sleeve for cracks, warpage, corrosion, scoring, or any other damage Replace crankcase and
piston if damage is found
NOTE
For piston replacement Instructions, refer to para 6-10.
c. Inspect studs (1 and 2). Replace the studs if damaged
d. Inspect oil drain plug (3) and drain plug washer seal (4)
e. Check that cylinder ID is greater than 2 684 inches (68 16 mm) If the ID Is greater than the wear limit, replace the
crankcase.
f. Inspect studs (5) Replace if studs are damaged
6-35/(6-36 blank)
