TM 10-4320-325-14
REMOVAL: Refer to Figure 4-13.
a. Loosen and remove wing nut (1).
b. Detach air cleaner housing cover (2).
c.
Remove air cleaner element (3).
d. Remove hex nuts (4), securing the air cleaner housing (5).
e. Remove air cleaner housing (5) and gasket (6). Discard gasket.
INSPECTION:
a. Check that air cleaner housing (5) and cover (2) are free from dirt.
b. Check air cleaner housing (5) and cover (2) for damage. Replace if necessary.
c.
Check air restriction indicator (7) for damage. Replace if necessary.
d. Check air intake hose (8) for damage. Replace if necessary.
e. Remove hex bolt (9), air intake bend (10), and gasket (11). Discard gasket.
INSTALLATION:
WARNING
Never run engine without the air cleaner element installed. Rapid
engine wear may result, causing death or serious injury.
a. Place new gasket (11) in place, position air intake bend (10), and secure with hex bolt (9).
b. Place new gasket (6) on intake manifold studs.
c.
Place air cleaner housing (5) over studs and secure with hex nuts (4).
d. Install air cleaner element (3) into air cleaner housing (4).
e. Replace air cleaner housing cover (2).
f.
Replace and tighten wing nut (1).
g. Reset the air cleaner restriction indicator by pressing the black button on top.
4-43
