TM 10-4320-315-10
CAUTION
Jack may come off bracket when pin is pulled
(4)
Remove jacks (14) from operation position and install in stow position as follows:
(a)
Use jack handle (15) to raise pad (13).
(b)
Remove locking pin (12).
(c)
Rotate jack (14) on bracket (16) to stow position.
(d)
Install locking pin (12) through jack (14) and bracket (16).
(e)
Pivot pad (13) on jack (14) to where top of pad faces trailer chassis. Then use jack handle (15) to place
edge of pad (13) against upper tube housing of jack (14).
NOTE
Placing pad in position against upper tube housing of jack secures the pad
during transit.
(5)
Using front tripod (4), raise front of pumping assembly slightly higher than pintle hook (11) of tow vehicle.
(6)
Back towing vehicle to align with trailer lunette (10). Attach safety chains (6) to towing vehicle at lifting
shackles (17) (one on each side) on towing vehicle. Lower pumping assembly to towing vehicle.
(7)
Attach breakaway cable (5) to lifting shackle (17) on towing vehicle.
(8)
Raise tripod (4) to transit position
(9)
Connect vehicle cable (2) to towing vehicle trailer receptacle (1).
(10) Release trailer hand brake (3).
NOTE
Pumping assembly is now ready for movement
2-11.
Operating Instructions on Decals and Instruction Plates. The location of decals and instruction plates are
illustrated on Figure 2-9.
2-29
