PMCS PROCEDURES (Continued) - TM-10-4320-310-14

PMCS PROCEDURES (Continued) - TM-10-4320-310-14_18

Table 2-2. Operator's Preventive Maintenance Checks and Services - Continued

TM-10-4320-310-14 Pump Unit Flammable Liquid Centrifugal Self-Priming 2-Inch 100 GPM Diesel Engine Driven NSN 4320-01-263-3604 Manual
Page Navigation
12

TM 10-4320-310-14 2-2. PMCS PROCEDURES (Continued) Equipment is allowable with minor oil leakages (Class I or II). Of course, you must consider the fluid capacity in the Item/system being checked/inspected. When in doubt, notify your supervisor. When operating with Class I or Class II oil leaks, continue to check fluid levels as required In your PMCS. All fuel leaks and Class II oil leaks should be reported to your supervisor or unit maintenance. Table 2-2. Operator's Preventive Maintenance Checks and Services NOTE If the equipment must be kept in continuous operation, check and service only those items that can be checked and serviced without disturbing operation. Make the complete checks and services when the equipment can be shut down. Perform weekly as well as before operation PMCS if: (1) You are the assigned operator and have not operated the item since the last weekly. (2) You are operating the item for the first time. Within designated interval, these checks are to be performed in the order listed. B - Before Operation A - After Operation M - Monthly D - During Operation W - Weekly B D A W M 1 Frame Assembly and Warning Plates Cracks are detected, or engine is loose. • Check attaching hardware used to mount components of centrifugal pump unit. Attaching hardware shall be tight and free of corrosion and damage. Components of pump attached directly to frame (1) are: Warning plate (2) Engine brackets (3) Identification plate (4) INTERVAL ITEM NO. ITEM TO BE INSPECTED PROCEDURE Equipment is Not Ready/ Available If 2-5

Privacy Statement
Press Release
Contact