ASSEMBLY - TM-10-4320-310-14

TM-10-4320-310-14 Pump Unit Flammable Liquid Centrifugal Self-Priming 2-Inch 100 GPM Diesel Engine Driven NSN 4320-01-263-3604 Manual
Page Navigation
141

TM 10-4320-310-14 6-4. REPAIR/REPLACE TIMING COVER AND CAMSHAFT (Continued) ASSEMBLY: 1 Assemble spacer (15), roller bearing (14), flanged wheel (13), circlip (12), wave washer (11), and hexagon nut (10) onto camshaft (9). . Handling heated parts can cause severe burns. Use proper equipment to handle heated parts. 2 Heat timing cover (4) to 120"F to 160° F (50° C to 70° C). Press in new ball bearing (8) and install intermediate ring (7). 3 While timing cover (4) is still hot, press in camshaft (9). INSTALLATION: 1 Install timing cover (4) using a new gasket (16). NOTE Make sure matchmarks on camshaft gear and crankshaft gear are aligned. 2 Install four hexagon head cap screws (1), two hexagon socket headcap screws (2) and joints (3). 6-14 4 Press in new bushing (5). 5 Install new oil seal (6). 6 Install cam followers (17 and 18) and shim (19) on spindle (20). Press spindle into crankcase (21) and secure with setscrew (22) installed above injection pump. Install plastic plug (23) in crankcase over setscrew.

Privacy Statement
Press Release
Contact