TM 10-4320-309-14
TM 4320-14/1
4-7. REPLACE/INSPECT/REPAIR DOOR, LATCH, AND HINGE
This task covers:
a) Inspection
c) Repair
b) Removal
d) Installation
INITIAL SETUP
Tools
Materials/Parts
Riveter, Blind Hand (Item 1,
Toluol Solvent (Item 10, Appendix E,
Appendix B, Section III)
Section II)
Tool Kit, GeneraI Mechanics (Item 2,
Cloth, Lint-free (Item 11, Appendix E,
Appendix B, Section III)
Section II)
Shop Equipment Automotive Maintenance
and Repair: Unit Maintenance,
Common No. 1 (Item 3, Appendix B,
Section Ill)
INSPECTION:
Do not inspect until engine has shutdown and cooled completely.
a.
Inspect rivets (7) holding latch (5), strike plate (6), hinge (3), and hinge spacer (4). If half the rivets of a
surface are missing, the components must be repaired.
b.
Inspect latch (5) and strike plate (6). Replace if inoperable or damaged.
c.
Inspect acoustical foam (8) within door (9). If acoustical foam blocks airflow or is tom, scarred, or
shows signs of contacting a hot engine surface, it must be replaced.
REMOVAL:
a.
b.
c.
d.
NOTE
Do not remove the door and hinge unless it is required to repair or re-
place the door, hinge, strike plate, or latch. Remove only those parts that
need to be repaired or replaced. Omit the other steps.
Remove four blind rivets (7) and remove door (9).
Remove four blind rivets (7) and remove hinge (3).
Remove two blind rivets (12) and remove strike plate (6).
Remove two blind rivets (7) and remove latch (5).
4-8
