TM 10-4320-309-14
TM 4320-14/1
INSTALLATION:
a.
b.
c.
d.
e.
Connecting rod is made of a special aluminum alloy. Avoid damage while
handling. Do not drop or clash against a hard object.
NOTE
Heating of piston should be done in an oil bath. Avoid direct heating.
Heat piston (1) to 160-180°F.
Line up the piston top identification mark “DM” and the ID number on the connecting rod as shown in
Figure 5-29
Align the small end hole of connecting rod (2) with the piston pin hole.
Insert piston pin (7) into the piston pin hole.
Insert two snap lock rings (8) into piston pin hole.
5-32
