TM 10-4320-309-14
TM 4320-14/1
Figure 5-28. Speed Control Device Springs
Attach return spring (3) to the governor lever and to regulator handle (2).
Attach regulator spring (1) to the second hole from the left (marked b) on the governor
lever and connect spring to second hole from the left (marked "2") on regulator handle (2).
Lubricate all moving parts with lubricating oil.
INSTALLATION:
a.
Governor Assembly (Refer to Figure 5-27)
(1) Install needle bearing (4) into cylinder block.
(2) Insert shaft (6) into governor control arm (12) and lock into position with taper pin (11).
(3) Install governor control arm (12), shaft (6), and washer (5) into needle bearing in engine from the inside.
(4) Insert thrust bushing (3) onto shaft (6) in cylinder block.
(5) Install control arm lever (2) onto shaft (6) and insert taper pin (1) into shaft.
b.
Speed Control Device (Refer to Figure 5-26)
(1) Install regulator coil spring (17).
(2) Mount regulator handle (2) to regulator bracket (5) using the handle locking nut (11).
(3) Mount regulator bracket assembly (5) with regulator handle (2) attached by installing two (2) mounting
bolts (12 and 16).
(4)
(5)
(6)
5-29
