TM 10-4320-309-14
TM 4320-14/1
b.
Remove air cleaner housing (5) from air intake bend (2).
c.
Remove gasket (3).
d.
Remove one bolt (4) holding air intake bend (2) to engine block.
e.
Remove air intake bend (2).
f.
Remove gasket (1).
INSPECTION:
a.
Check that gaskets (1 and 3) are clean and undamaged.
b.
Check that intake bend housing (2) is free from dirt.
INSTALLATION:
a.
Position gasket (1) carefully in place over two studs on the cylinder block.
b.
Position air intake bend (2) onto studs and install hex head bolt (4).
c.
Carefully place gasket (3) in position on face of bend, lining up bolt holes.
d.
Attach air cleaner housing (5) over three studs (6). Make sure gasket is still in position and install three
nuts (7) onto studs.
e.
Tighten three nuts (7) securely and air intake bend securing bolt (4).
4-38
