Section IV. REMARKS - TM-10-4320-307-24

TOOL AND TEST EQUIPMENT REQUIREMENTS - TM-10-4320-307-24_565

Appendix C. EXPENDABLE/DURABLE SUPPLIES AND MATERIALS LIST

TM-10-4320-307-24 Pump Assembly (Mainline) Diesel Engine Driven 800 GPM NSN 4320-01-193-3430 Manual
Page Navigation
560

TM 10-4320-307-24 Section IV. REMARKS REFERENCE CODE REMARKS A Direct support repair is limited to welding and removal of gauges and dents. B Vent valves are welded in place; repair by replacing valve parts that are malfunctioning. C Prior to mounting the cover on the pump casing, evenly spread adhesive, chesterton type 860, over the surfaces. D If repair requires replacement of the casing on cover, they must be procured as a matched set. E Secure the bearing housing sealing surfaces with Ermetite. F Secure the lock pin with sealing compound (Loctite). G To replace the ball bearing, heat on an electric plate at a temperature of approximately 100°C. H Secure the setscrews with sealing compound (Loctite). I Each time mechanical seal is replaced or disassembled. replace the packing. J After replacing new impeller, balance the shaft and impeller with balancing machine. K When replacing the original impeller, balancing is not required. L To assemble, heat the impeller wear ring at a temperature of approximately 350°C. M Before reassembling the shaft, check the concentricity of the working points. N After replacing shaft. balance the shaft and impeller with balancing machine. 0 Crew inspection limited to the visual check for damaged or loose parts. P Not procurable as an assembly. Replacement is reserved for component parts only. Q Organizational maintenance is limited to the replacement of external components. R Direct maintenance is limited to the repair of the heat exchanger. S Tanks and core to be repaired by direct support maintenance. T Crew limited to the inspection of external components. U Core to be repaired by direct support maintenance. V Straightening a major repair to be accomplished by general support maintenance. W Direct support limited to the replacement of the shaft oil seals. X Starter and alternator tests may be performed at both unit and direct support maintenance levels. Y Removal of flexible coupling is authorized at unit level only for preparation for shipment. B-11/(B-12 blank)

Privacy Statement
Press Release
Contact