TM 10-4320-307-24
Section VI.
MAINTENANCE PROCEDURES
INDEX
Para
Para
Aftercooler Repair/Replace ................................. 2-47
Idler Assembly Repair/Replace ........................... 2-49
Air Cleaner Assembly Service/Repair/
Junction Box Repair/Replace .............................. 2-32
Replace ........................................................ 2-38
Lubrication Oil Filter/Cooler Service/
Alternator Test/Replace ....................................... 2-42
Replace ........................................................ 2-52
Bail Lifting Assembly Repair/
Network Cable Test/Replace ............................... 2-33
Replace .... .................................................... 2-19
Oil Drain Assembly Repair/
Batteries, Battery Box, and Battery
Replace .. ...................................................... 2-55
Cable Assembly Service/Test/
Piping and Vent Assembly
Repair/Replace ............................................. 2-27
Replace ........................................................ 2-26
Cabinet Enclosure Repair..................................... 2-29
Pump Assembly Service ...................................... 2-25
Cold Starting Aid Assembly
Radiator Assembly Service/Test/
Replace ........................................................ 2-37
Repair/Replace ............................................. 2-35
Conduit Layout Repair/Replace ........................... 2-31
Rocker Lever Adjust ............................................ 2-54
Corrosion Resistor Assembly Service/.........................
Rocker Lever Cover Assembly
Repair/Replace ............................................. 2-44
Repair/Replace ............................................. 2-53
Drive Belts Adjust/Replace .................................. 2-41
Speed Increaser Service/Repair .......................... 2-34
Engine Enclosure Repair/
Starter Assembly Test/Replace ........................... 2-43
Replace ........................................................ 2-23
Storage Box and Cover
Engine Exhaust System Repair/
Repair/Replace ............................................. 2-24
Replace ........................................................ 2-18
Suction and Discharge Cover
Engine Service .................................................... 2-36
Repair/Replace ............................................. 2-56
Exhaust Manifold Assembly
Tank Assembly Repair/Replace .......................... 2-22
Repair/Replace ............................................. 2-46
Thermostat Housing Assembly
Fan Hub and Bracket Replace ............................. 2-48
Repair/Replace ............................................. 2-45
Feeding System Repair/Replace ......................... 2-21
Turbocharger Plumbing Repair/
Field Instrument Layout Test/
Replace ........................................................ 2-39
Repair/Replace ............................................. 2-30
Turbocharger Replacement
Fuel Filter Assembly Service/
Repair/Replace ............................................. 2-40
Repair/Replace ............................................. 2-51
Water Pump Assembly Replace .......................... 2-50
Grounding Assembly Repair/
Wiring Gages, Switches, and Indicators
Replace ........................................................ 2-20
Test/Repair/Replace ..................................... 2-28
2-17
GENERAL INSTRUCTIONS. Most maintenance instructions in this section will list resources required, personnel
required, and equipment condition for the start of the procedure. Note the following.
a.
Resources required are not listed unless they apply to the procedure.
b.
Personnel required are listed only if the task requires more than one. If PERSONNEL is not listed. it means
one person can do the task.
c.
The normal standard equipment condition to start a maintenance task is engine stopped and START/ STOP
switch set at STOP. EQUIPMENT CONDITION is not listed unless some other condition is required besides
the power being off.
d.
Refer to Appendix D to determine torque requirements when tightening threaded fasteners, unless a specific
torque value is given in the procedure. Standard torque values given in Appendix D are determined by
thread size.
2-37
