TM 10-4320-307-24
2-48
FAN HUB AND BRACKET REPLACE (CONT).
INSTALLATION:
1.
Install fan support (1) to engine block with two
captive capscrews (2) . Tighten to 75 in-lb (100
Nm) torque.
2.
Install fan brace (3) using two capscrews (4) with
lockwashers (5) and washers (6) and two captive
capscrews (7).
NOTE
Step 3 applies only if a new assembly is being used.
3.
Remove two capscrews and lockwashers (8)
and take protective shipping cover (9), fan pilot
spacer (10), and fan spacer gasket (11 ) off fan
pulley (12).
2-202
