TM 10-4320-307-24
2-44
CORROSION RESISTOR ASSEMBLY SERVICE/REPAIR/REPLACE. (CONT).
1.
Remove coolant system pressure cap (1) from radiator
(2).
2.
Close shutoff valves (3 and 4).
3.
Loosen hose clamp (5) and remove hose (6) from hose
elbow (7).
CAUTION
Use clean container with a cap to prevent entry
of
foreign
material.
Introduction
of
contaminants or foreign matter may cause
premature
failure
of
cooling
system
components.
4.
Place hose (6) into clean, capped container and slowly
open valve (4), allowing coolant to drain into
container, until flow stops.
NOTE
Save the coolant.
5.
Remove and discard coolant filter (8).
6.
Loosen three hose clamps (9).
7.
Remove hoses (6 and 10).
8.
Unscrew and remove shutoff valves (3 and 4).
9.
Remove adapter (11).
10.
Remove elbows (12).
11.
Remove hose elbows (7 and 13).
12.
Remove
four
capscrew
and
captive
washer
assemblies (14) and remove corrosion resistor head
(15).
13.
Remove
two
capscrew
and
captive
washer
assemblies (16) with washers (17) and remove
bracket (18) from engine.
2-179
