TM 10-4320-226-14WARNINGTo prevent rolling or sliding, do not work on equipment that is not securely stabilized.Ensure both wheels of the equipment are chocked, Failure to obey this warning mayresult in serious injury.Refer to Figure 3-2 and proceed as follows:a.Loosen two wing nuts (1), one on each side, that secure holding strap (2) to battery cases (3).b.Disengage eye bolts (4) from strap slots (5).c. Remove strap (2)d.Remove battery access covers (6).e.Inspect battery cables (7 and 8) for corrosion, If severely corroded, notify Unit Maintenance.f.Remove six caps (9) on each battery.NOTEElectrolyte level must cover lead plates and extend to the lower edge of the fill hole.g.Visually check the electrolyte level of all cells,WARNINGElectrolyte causes serious burns. Do not fill batter without rubber gloves and protectiveclothing. Failure to obey this warning may result in injury or death.h.When electrolyte level is low, add distilled water.i.Install six caps (9) on each battery.j.Position battery access covers (6) on batteries.k.Position strap (2) with flat side up on battery access covers (6).l.Engage eye bolts (4) in strap slots (5).m.Tighten wing nuts (1) on eye bolts (4) to apply equal pressure on strap (2).Change 2 3-7
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
