TM 10-4320-226-14
NOTES
1.
EACH WIRE SHALL BE MARKED ON BOTH ENDS WITH APPROPRIATE WIRE NO.AS SHOWN IN TABULATION BLOCK.
EXAMPLE: TB1 .+ S1-1
PERMANENCY LEGIBILITY AND TYPE OF LETTERING SHALL BE IN ACCORDANCE WITH MIL-STD-130.
2.
ROUTING CHANGES MAY BE MADE TO FACILITATE INSTALLATION.
3.
WIRING SHALL BE BUNDLED IN ACCORDANCE WITH REQUIREMENT 69 OF MIL-STD-454.
4.
INSTALLED TERMINALS, FIND NO. 16-22, SHALL MEET THE PERFORMANCE REQUIREMENTS
OF MIL-T-454, REQUIREMENT 19.
5.
BUNDLE CABLE AND TIE WRAP USING STRAP FIND NO. 25 AS REQUIRED.
6.
MARK HARNESS IN ACCORDANCE WITH MIL-STD-130.
Figure F-2. Control Panel Wiring Harness Assembly (Model 350 PAW and W-87012) (Sheet 1 of 3).
Change 2 F-7
