TM 10-4320-226-14Do not lift heavy assemblies without lifting device.Failure to obey thiswarning may result in personal injury or death.d.Place sling of adequate size around centrifugal pump (12) and attach enginesling.e.Place a jackstand under each side of the rear trailer frame for support.f.With weight of centrifugal pump (12) on engine sling, slowly and carefullypull centrifugal pump (12) back until flexible coupling disengages fromconnection ring.g.Pull centrifugal pump (12) completely clear of engine.h.Carefully remove centrifugal pump (12) clear of frame.i.Tag and remove any shims.Retain shims for installation.5.6.1.2 Installation.a.b.c.d.e.f.h.Do not lift heavy assemblies without lifting device.Failure to obey thiswarning may result in personal injury or death.Place lifting strap of adequate size around centrifugal pump (12) and connectengine sling.Raise centrifugal pump (12) and position over frame.Slowly lower centrifugal pump (12), aligning flexible coupling with connectionring observed through openings (13) on either side of intermediate bracket.Push centrifugal pump (12) toward engine and guide flexible coupling untilcoupling engages with coupling on engine.Secure centrifugal pump (12) as follows:(1)(2)(3)(4)(5)(6)Install shims between pump and frame.Remove tags.Install two bolts (7), washers (8), beveled washers (6), and locknuts (5).Do not tighten.Install four bolts (1), lockwashers (2), and washers (3) to secure twointermediate bracket covers (4).Install remaining eight bolts (1), and lockwashers (2).Install bracket (11), lockwasher (10), and nut (9).Torque all hardware installed in accordance with Appendix G.Remove jackstands at rear of trailer.Refer to LO 10-4320-226-12 and add oil as necessary.5-33
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
