TM 10-4320-325-14
Section I. GENERAL SUPPORT REPAIR PARTS, SPECIAL TOOLS, TEST,
MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE), AND SUPPORT EQUIPMENT
6-1. COMMON TOOLS AND
EQUIPMENT.
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE)
applicable to your unit.
6-2. SPECIAL TOOLS, TMDE, AND
SUPPORT EQUIPMENT.
The special tools required to service the centrifugal pump are listed and illustrated in TM 10-4320-325-24P, Repair Parts
and Special Tools List (RPSTL), and In the Maintenance Allocation Chart (MAC) located in Appendix B of this manual.
Repair parts are listed and illustrated in TM 10-4320-325-24P.
Section II. GENERAL SUPPORT MAINTENANCE PROCEDURES
6-4. GENERAL INSTRUCTIONS.
a. Unless otherwise stated, one person can perform the task listed.
b. The normal standard equipment condition to start a maintenance task is engine stopped.
c. Refer to Appendix G to determine torque requirements when tightening threaded fasteners, unless a specific
torque value is given in the procedure. Torque values in Appendix G are determined by thread size.
6-2