TM 10-4320-226-14
4.16.5.1 Removal.
To prevent rolling or sliding, do not work on equipment that is not
securely stabilized.
Ensure both wheels are secure.
Do not lift heavy assemblies without lifting device.
Failure to obey these warnings may result in personal injury or death.
a.
Stabilize trailer.
b.
Using jack, carefully tilt entire assembly until enough clearance is attained
to remove support leg (figure 4-61, 1).
c.
Position two jack stands directly behind support leg housing.
Remove jack.
d.
Remove retaining pin (2).
e.
While holding support leg (1), remove anchor pin (3).
f.
Remove support leg (1).
4.16.5.2 Installation.
a.
Position support legs (1), align anchor pin holes, insert anchor pins (3).
b.
Install retaining pins (2).
c.
Using jack, raise until jack stands can be removed.
d.
Remove jackstands.
e.
Lower assembly until support legs (1) are fully down.
Remove jack.
4-114