WARNINGDrycleaning solvent, P-D-680, used to clean parts, is potentially dangerousto personnel and property. Avoid repeated and prolonged skin contact. Donot use near open flame or excessive heat. Flash point of solvent is 100°Fto 138°F (38°C to 59 °C).a. Clean parts with drycleaning solvent (item 1, Appendix E) and dry thoroughly.b. Inspect the drain cock for damage or defects. Clean as required. If replacement is necessary,notify Organizational Maintenance.c. Check the ball in the water sight gage. It should not be above the line mark on the window. If ballis above the link mark, drain the filter/separator by opening the drain cock. Do not allow the fuel to spillon pump unit or vehicle bed.d. Inspect differential pressure during operation. If gageOrganizational Maintenance for replacement of filter elements.is not shown in the green, notify3-6. GASOLINE CANa.Inspect the engine gasoline can for leaks and damage. Refer to figure 1-2 for location.b. Replace defective can.3-7.POWERCABLESa.Inspect for damage or defects.b. Replace defective cables.3-8. FUEL DISPENSING NOZZLE ASSEMBLYa. Inspect nozzle assembly (figure 3-2) for freedom of lever, or missing parts. If leverdoes not operate freely or if ground strap is broken or missing, replace nozzle.(1) Removal. Open nozzle and drain fuel into suitable container. Remove nozzle by pulling out oncam arms and disconnecting coupling.(2) Installation. Connect couplings and close cam arms.b. Inspect gasket on coupler end of nozzle. If damaged, replace gasket.3-8TM5-4930-230-13
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business