TM 5-4930-227-14Section Vlll. ENGINE STARTING AND COOLING SYSTEM3-18. Generalb. Cleaning and Inspection.Starting is accomplished by using a pulley andrope arrangement. The engine flywheel acts as afan, forcing air into the air shroud which distri-butes this cooling air around the crankcase andcylinder head.(1) Clean all parts with an approved clean-ing solvent and dry thoroughly.(2) Inspect all parts for cracks, dents,breaks, and other damage. Replace a defectivepart.(3) Inspect the mounting hardware for3-19. Starter Pulleya. Removal. Refer to figure 3-7 and removethe starter pulley.b. Cleaning and Inspection.(1) Clean all parts with an approved clean-ing solvent and dry thoroughly.(2) Inspect all parts for cracks, breaks,damaged threads, and other defects. Replace adamaged part.c. Installation. Refer to figure 3-7 and installthe starter pulley.3-20. Air Shrouda. Removal.(1) Remove the starter pulley (para 3-19).(2) Refer to figure 3-7 and remove the airshroud.cracks, breaks, and damageddamaged or missing part.c. Installation.(1) Refer to figure 3-7shroud.threads. Replace aand install the air(2) Install the starter pulley (para 3-19).3-21. Flywheela. Removal.(1) Remove the air shroud (para 3-20).(2) Refer to figure 3-8 and remove the fly-wheel.b. Cleaning and Inspection.(1) Clean all parts with an approved clean-ing solvent and dry thoroughly.(2) Inspect all parts for cracks, breaks, andother damage. Replace a defective part.c. Installation.(1) Refer to figure 3-8 and install the fly-wheel.(2) Install the air shroud (para 3-20).3-12
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
