TM 5-4320-302-144-22.FUEL TANK LINES AND FITTINGS ( CONT)Location/ItemActionRemarksWARNINGPriming discharge mixture of water and exhaust gasesmay cause severe burns or injury. Wear gloves andsafety glasses when priming pump.Stand clear of venturi during priming.CAUTIONPrime the centrifugal pump as soon as possible afterengine starts. Rotation of impeller without water involute will damage pump components.To prevent starter from overheating, do not crankengine with starter for more than 10 seconds.Battery life will be lengthened if 60 seconds is allowed toelapse between starting attempts.Under any condition, if engine does not start on initialattempt, allow engine rotation to stop completely beforeagain engaging starter.15.THROTTLEPull THROTTLE T-handle full open and lock byT-handleturning clockwise.16.Control panelPress and hold in the fault sensitive control push-button, push START button and observe fuel flowfrom injector fittings until air is cleared from lines.17.InjectorsTighten line nuts on injectors.18.THROTTLEPush THROTTLE T-handle closed.T-handle19.EngineStart engine as described in paragraph 2-5.4-117
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business