TM 5-4320-275-13 & P
GEAR REDUCER (CONT)
LOCATION/ITEM
ACTION
REMARKS
4. Gear
Use gear and bearing mechanical puller to remove
gear (4) from output shaft (6). Remove key (5).
5. Input cover
Use 9/16 inch socket and handle to
remove eight cap screws (1). Re-
move input cover (2). Remove and
discard input seal (3).
6. Input shaft
Use retaining ring pliers to remove snap ring (1)
from input cover (2). Remove input shaft (5)
with bearings (3 and 4) from input cover (2).
7. Bearings
Use gear and bearing mechanical puller to re-
move input cover bearing (3) and input bearing
(4) from input shaft (5).
NOTE
Pinion and input shaft are a permanent assembly. Do not attempt to separate them.
5-16
