TM 5-4320-274-14&P
CHAPTER 1
INTRODUCTION
Section I. GENERAL
1-1. Scope
This manual is for your use in operating and maintaining the E. C. Schleyer Pump Co. Model 4M-SE2000 electrical
motor driven pump. Chapters 1 through 4 provide information relative to the operation, preventive maintenance and
organizational maintenance of the equipment. Chapter 5 provides information on the direct support and general support
maintenance. Chapter 6 provides repair instructions, and Chapter 7 provides information on administrative storage.
1-2. Maintenance Forms and Records
Maintenance forms and records that you are required to use are explained in TM 38-750.
1-3. Equipment Serviceability Criteria (ESC)
This equipment is not covered by an ESC.
Section II. DESCRIPTION AND DATA
1-4. Description
a. General.
The electrical motor driven pump (fig. 1-1) is a
portable, frame mounted unit designed to
pump water
at the rate of 65 gpm (gallons per minute) at 50 ft-tdh (feet-total dynamic head).
b. The pump is equipped with a Baldor Electric Co. motor, Model 617M. The motor is a 2 hp (horse- power) unit
encased in a heavy duty housing. It is a totally enclosed fan cooled motor provided with permanently lubricated
c. If you need a detailed description of any component of the electrical motor driven pump, refer to the applicable
organizational maintenance information.
1-5. Identification and Tabulated Data
The E. C. Schleyer pump, Model 4M-SE2000, has three identification plates. The information on these plates
follows:
a. Troop Support Command Identification Plate.
Manufacturer ........................................ E. C. Schleyer Pump Co., Inc.
Model ............. ...................................... 4M-SE2000
Serial ............. ...................................... R113 (thru R523)
Nomenclature........................................ Pump, centrifugal, self- priming, frame mounted, 1 1/2 in.
Capacity ............................................... 65 gpm
NSN ................ ..................................... 4320-01-010-5888
Drive ............. ....................................... EMD (Electric motor driven)
Contract ............ ................................... DSA700-75-C-8357
Code Ident ............. .............................. 97403
b. Pump Manufacturers Identification Plate.
Nomenclature ....................................... Pump, centrifugal, 1 1/2 in., frame mtd, EMD, fresh water, 65 gpm, 50 ft. head
Model .............. ..................................... 4M-SE200
Contract .............. ................................. DSA700-75-C-8357
Serial ............. ...................................... R113 (thru R523)
Capacity ............................................... Blank
Registration No ........... ......................... Blank
GVW .................................................... Blank
Length .................................................. 21 in. (53.3 centimeters)
NSN .............. ....................................... 4320-01-010-5888
Date Mfd ............. ................................. As applicable
Height ............. ..................................... 22 in. (55.8 centimeters)
Eng Ser ................................................ Blank
Ship Wt ............. ................................... 110 lb. (49.5 kilograms)
Width ............. ...................................... 13 in. (33 centimeters)
Warranty ............. ................................. Blank
Month ................................................... Blank
Miles ............. ....................................... Blank
Cube ............. ....................................... 4 ft. (0.112 cubic meters)
Date shipped ............. ........................... As applicable
Date Insp .............. ............................... As applicable
Mfd by .................................................. E. C. Schleyer Pump Co., Inc., Anderson, Indiana
1-1