TM 5-4320-234-34P
(4) FIG. column. This column lists the number of the figure where the item is identified/located in
Sections II and Ill.
(5) ITEM column. The item number is that number assigned to the item as it appears in the figure
referenced in adjacent figure number column.
c. FIGURE AND ITEM NUMBER INDEX.
(1) FIG. column. This column lists the number of the figure where the item is identified/located in
Section II and III.
(2) ITEM column. The item number is that number assigned to the item as it appears in the figure
referenced in the adjacent figure number column.
(3) STOCK NUMBER column. This column lists the NSN for the item. (4) FSCM column. The
Federal Supply Code for Manufacturer (FSCM) is a 5-digit numeric code used to identify the
manufacturer, distributor, or Government agency, etc., that supplies the item.
(5) PART NUMBER column. Indicates the primary number used by the manufacturer (individual, firm,
corporation, or Government activity), which controls the design and characteristics of the item by
means of its engineering drawings, specifications standards, and inspection requirements to identify
an item or range of items.
5. SPECIAL INFORMATION.
a. USABLE ON CODE. The usable on code appears in the lower left corner of the Description column
heading. Usable on codes are shown as "UOC: in the Description Column (justified left) on the last line
applicable item description/nomenclature. Uncoded items are applicable to all models.
b. ASSOCIATED PUBLICATIONS. The publications listed below pertains to the Pumping Assembly
(Model US90CCG-1) and its components.
Publication
Short Title
LO 5-4320-234-12
Pump, Centrifugal, Self-Priming
TM 5-4320-234-12
Pump, Centrifugal, Self-Priming
TM 5-4320-234-34
Pump, Centrifugal, Self-Priming
TM 5-4320-234-20P
Pump, Centrifugal, Self-Priming
6. HOW TO LOCATE REPAIR PARTS.
a. When National Stock Number or Part Number is NOT known.
(1) First. Using the table of contents, determine the assembly group or subassembly group to which the
item belongs. This is necessary since figures are prepared for assembly groups and subassembly
groups, and listings are divided into the same groups.
(2) Second. Find the figure covering the assembly group or subassembly group to which the item
belongs.
(3) Third. Identify the item on the figure and note the item number.
7
