TM 5-4320-215-25P
SECTION I.
INTRODUCTION
1. Scope This manual lists repair parts required
Code
Explanation
for the performance of organizational, direct support,
A
Assemblies which are not procured or stocked
general support, and depot maintenance of the pump.
as such, but are made up of two or more units
Such component units carry individual stock
2.
General This Repair Parts and Special Tools
numbers and descriptions are procured and
List is divided into the following sections:
stocked separately and can be assembled to
a Prescribed Load Allowance (PLA)-Section II.
form the required assembly at indicated
A composite listing of repair parts, special tools, test and
maintenance categories.
support equipment having quantitative allowances for
X
Parts and assemblies which are not procured or
initial stockage at the organizational level.
stocked and the mortality of which normally is
b Repair Parts Section III
A list of repair
below that of the applicable end item or
parts authorized for the performance of maintenance at
component The failure of such part or
the organizational level in figure and item number
assembly should result in retirement of the end
sequence.
item from the supply system
c Special Tools, Test and Support Equipment
X1
Repair parts which are not procured or stocked
Section IV A list of special tools, test and support
The requirement of such items will be filled by
equipment authorized for the performance of
the use of the next higher assembly or
maintenance at the organizational level Not applicable.
component.
d Repair Parts Section V A list of repair parts
X2
Repair parts which are not stocked
The
authorized for the performance of maintenance at the
indicated maintenance category requiring such
direct support, general support, and depot level in figure
repair parts will attempt to obtain them through
and item number sequence.
cannibalization Where such repair parts arc
e Special Tools, Test and Support Equipment
not obtainable through cannibalization,
Section VI A list of special tools, test and support
requirements will be requisitioned, with
equipment authorized for the performance of
accompanying justification, through normal
maintenance at the direct support, general support, and
supply channels.
depot level Not applicable.
G
Major assemblies that are procured with PEMA
f: Federal Stock Number and Reference
funds for initial issue only as exchange
Number Index Section VII A list of Federal stock
assemblies a DSU and GSU level These
numbers in ascending numerical sequence, followed by
assemblies will not be stocked above GS and
a list of reference numbers appearing in all of the
DS level or returned to depot supply levels.
Maintenance code. Indicates the lowest
listings, in alpha-numeric sequence, cross-referenced to
(2)
the illustration figure number and item number.
category of maintenance authorized to install the listed
item The maintenance codes are:
Note Items not
illustrated
are
cross-
referenced to page number.
Code
Explanation
3. Explanation of Columns
0
Organizational maintenance
F
Direct support maintenance
The following provides an explanation of columns in the
H
General support maintenance
tabular lists in sections II through IV.
D
Depot maintenance
a Source, Maintenance, and Recoverability
(3) Recoverability code Indicates
whether
Codes (SMR).
unsericeable items should be returned for recovery or
(1) Source code. Indicates the selection status
salvage Items not coded are expendableRecoverability
and source for the listed item Source codes used are:
codes are:
Code
Explanation
Code
Explanation
R
Repair parts and assemblies which are
P
Repair parts which are stocked in or
economically repairable at DSU and GSU
supplied from the GSA/DSA, or Army
activities and are normally furnished by supply
supply system and authorized for use at
on an exchange basis.
indicated maintenance categories.
S
Repair parts and assemblies which are
economically reparable at DSU and GSU
P2
Repair parts which are procured and stocked for
activities and which normally are furnished by
insurance purposes because the combat or
military essentially of the end item indicates
supply on an exchange basis. When items are
that a minimum quantity be available in the
determined by a GSU to be uneconomically
supply system.
reparable they will be evacuated to a depot for
evaluation and analysis before final disposition.
M
Repair parts which are not procured or stocked,
T
High dollar value recoverable repair parts which
but arc to be manufactured in indicated
are subject to special handling and are issued
maintenance levels.
on an exchange basis. Such repair parts are
normally repaired or overhauled at depot
maintenance activities.
iii
Code
Explanation
