TM 5-4320-208-12&Pb.D i s c o n n e c t e x h a u s t p i p e e x t e n s i o n i f u s e d.c .R e m o v e p l u g f r o m b o t t o m o f f u e l t a n k a n d d r a i n f u e l i n t o s u i t - a b l e c o n t a i n e r .d.C o v e r o p e n i n g s o f i n l e t a n d o u t l e t a d a p t e r s t o p r o t e c t a d a p t erthreads and prevent foreign matter from entering pump.2 - 8.REINSTALLATION AFTER MOVEMENT.R e f e r t o p a r a g r a p h 2 - 4 . 4 f o r i n s t a l l a t i o n a n d s e t t i n g u p p r o-c e d u r e s.Section IV.OPERATION UNDER UNUSUAL CONDITIONS2 - 9.GENERAL.T h i s s e c t i o n c o n t a i n s i n s t r u c t i o n s f o r o p e r a t i o n o f t h e e q u i p m e nti n t h e f o l l o w i n g c o n d i t i o n s :extreme cold, extreme heat, dusty orsandy areas, rainy or humid conditions, salt water areas, and higha l t i t u d e s .2 - 1 0.OPERATION IN EXTREME COLD.a.K e e p f u e l t a n k f u l l t o p r e v e n t c o n d e n s a t i o n .Drain and ser-v i c e f u e l f i l t e r m o r e f r e q u e n t l y t h a n u n d e r n o r m a l c o n d i t i o n s ( p a r a-g r a p h 3 - 5 . 2 ) .b.Before starting engine, remove any accumulated ice or snowfrom spark plugs and wiring.c .Make sure Inlet Air Temperature shutter on engine is set forw i n t e r o p e r a t i o n .d.Run engine at low speed to warm to operating temperature be-f o r e a p p l y i n g f u l l l o a d.Lubricate engine in accordance with current lubrication orderLO 5-2805-257-12.e .f .Fill pump with warm water to prevent freezing at starting.9“Drain pump immediately after operation as shown in figure 2-4.2-14
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
