TM 10-4930-236-13&P
Table 3-1. Troubleshooting - CONT
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 1.
If problem still exists:
Refer to Unit Maintenance.
6
FUEL FLOW WILL NOT STOP WHEN TANK IS FULL
Step 1.
Check for valve operator lever in ON position.
Move lever to CLOSE position.
Step 2.
If malfunction still exists:
Shut off flow, then refer to Unit Maintenance.
SECTION III. MAINTENANCE PROCEDURES
3-3 GENERAL. Operator maintenance on tank and pump unit consists of only those tasks and procedures
stated in the Operator Preventive Maintenance Checks and Services (PMCS) Chart. Refer to the Operator's
PMCS Chart and perform all tasks outlined at the intervals stated in the chart.
3-3/(3-4blank)
