TM 10-4930-204-13pump, engine/electric motor, filter/separator, manifold, static dis-charge reel, fuel dispensing nozzle assembly, fuel dispensing reel as-sembly and frame assembly.Ensure drainage of pump, manifold assembly andhoses to preclude fuel spills during maintenance.4-20.HOSES.a.General.The tank and pump unit contains several flexiblerubber hoses with quick-disconnect couplings, either male or female.The tanks to manifold hoses connect each tank to the pumping assemblymanifold.The manifold to pump hose connects the manifold to the pumpinlet connection.The pump to filter/separator hose connects the pumpoutlet to the inlet of the filter/separator.The filter/separator toquick-disconnect tee connects the filter/separator outlet to thequick-disconnect tee.Two hoses connect the quick-disconnect tee tothe left and right dispensing reels.A dispensing hose with nozzleis connected to and wound onto each dispensing reel.b.Removal.Refer to figure 4-6 for removal of the hoseassemblies.c.Cleaning andInspection.Drycleaning solvent normally has a flash pointof either 100 or 138 degrees F, depending on thetype being used, but may flash at much lower tem-peratures if contaminated with gasoline or jetfuel.Avoid repeated and prolonged skin contact.Do not use near open flame or excessive heat.(1) Clean metal parts with drycleaning solvent (item 1,App. F), and dry thoroughly.Clean hose surfaces with a clean, drycloth .(2) Inspect hoses and associated parts for signs ofdeterioration and wear.(3) Replace defective hoses, couplings and adapters asnecessary.d.Installation.Refer to figure 4-6 for installation of thehose assemblies.4-20
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
