TM 10-4630-207-13&P
0005 00
2. Position the prime mover so that its towing pintle (figure 3, item 1) is located close to the lunette eye
(figure 3, item 2) of the trailer.
1
2
Figure 3. Connecting WWET/T to Prime Mover
NOTE
If the same prime mover is habitually used with the WWET/T, the trailer lunette eye
should be adjusted to the proper height to mate with the prime mover towing pintle.
3. To adjust the height of the lunette eye (figure 4, item 1), if necessary, remove two lock nuts (figure
4, item 2) and two lag bolts (figure 4, item 3) that secure the lunette eye to the leveler slide (figure
4, item 4). Adjust the lunette eye to the desired height, then re-install and tighten two lag bolts and
lock nuts.
4
1
2
3
Figure 4. Lunette Eye Adjustment
4. Raise or lower the trailer as necessary with the jack (figure 5, item 1) so that the lunette eye (figure
5, item 2) is at the same height as the towing pintle (figure 5, item 3) of the prime mover.
0005 00-3
