TM 10-4320-344-24P-1
g .
The usable on code, when applicable (see paragraph 5, Special information).
h. In the Special Tools List section, the Basis of issue (BOI) appears as the last
line(s) in the entry for each special tool, special TMDE, and other special
support equipment.
When density of equipments supported exceeds density spread
indicated in the basis of issue, the total authorization is increased
proportionately.
i. The statement "END OF FIGURE" appears just below the last item description in
Column 5 for a given figure in both Section II and Section III.
3.2.6.
(QTY (Column (6)).
The QTY (quantity per figure column) indicates the quantity
of the item used in the breakout shown on the illustration figure, which is
prepared for a functional group, subfunctional group, or an assembly.
A "V"
appearing in this column in lieu of a quantity indicates that the quantity is
variable and the quantity may vary from application to application.
4. EXPLANATION of COLUMNS (SECTION IV).
4.1. NATIONAL STOCK NUMBER (NSN) INDEX.
4.1.1.
STOCK NUMBER column.
This column lists the NSN by National Item Identification
Number (NIIN) sequence.
The NIIN consists of the last
NSN
nine digits of the NSN (i.e., 5305-01-674-1467).
When using this
NIIN
column to locate an item, ignore the first 4 digits of the NSN.
However, the
complete NSN should be used when ordering items by stock number.
4.1.2.
FIG. column.
This column lists the number of the figure where the item is
identified/located.
The figures are in numerical order in Section II and Section
III.
4.1.3.
ITEM column.
The item number identifies the item associated with the figure
listed in the adjacent FIG. column.
This item is also identified by the NSN listed
on the same line.
4.2.
PART NUMBER INDEX.
Part numbers in this index are listed by part number in
ascending alphanumeric sequence (i.e., vertical arrangement of letter and number
combination which places the first letter or digit of each group in order A through
Z, followed by the numbers 0 through 9 and each following letter or digit in like
order).
4.2.1.
FSCM column.
The Federal Supply Code for Manufacturer (FSCM) is a 5 digit
numeric code used to identify the manufacturer, distributor, or Government agency,
etc., that supplies the item.
4.2.2.
PART NUMBER column.
Indicates the primary number used by the manufacturer
(individual, firm, corporation, or Government activity), which controls the design
and characteristics of the item by means of its engineering drawings,
specifications standards, and inspection requirements to identify an item or range
of items.
4.2.3. STOCK NUMBER column.
This column lists the NSN for the associated part number
and manufacturer identified in the PART NUMBER and FSCM columns to the left.
4.2.4. FIG. column.
This column lists the number of the figure where the item is
identified/located in Section II and III.
4.2.5. ITEM column.
The item number is that number assigned to the item as it appears
in the figure referenced in the adjacent figure number column.
6
