TM 10-4320-315-24
2-39. MAINTENANCE OF AIR CLEANER AND AIR INTAKE LINE
This task covers:
a.
Remove
b.
Install
INITIAL SETUP
Tools
Equipment Conditions
General Mechanics Tool Kit
Pumping assembly is shutdown (refer to TM 10-4320-
315-10).
(Item 1, Appendix B)
Battery assembly is disconnected (para. 2-16).
Materials/Parts
Air filter hose line is disconnected (para. 2-34).
Lockwashers (TM 10-4320-315-24P)
a.
REMOVE, (Figure 2-26)
(1)
Open air cleaner access door.
(2)
Disconnect fitting (1) of cold start aid line (2) on air inlet pipe (3).
(3)
Loosen hose clamp (4) on intake line elbow (5).
(4)
Remove nuts (6), lockwashers (7), flat washers (8), bolts (9), and air cleaner (10).
(5)
Loosen hose clamps (11) and remove elbow (12) and intake line (3).
(6)
Loosen hose clamps (13) and remove rubber flex hose (14) with pipe (15) from engine turbocharger (17).
(7)
Loosen hose clamp (16) and remove elbow (5) from pipe (15).
b.
INSTALL.
(1)
Install rubber flex hose (14) with pipe (15) on engine turbocharger (17) with hose clamps (13).
(2)
Install elbow (5) on pipe (15) with hose clamp (16).
(3)
Install elbow (12) and intake line (3) on air cleaner (10) with hose clamps (11).
(4)
Install air cleaner (10) in air cleaner compartment with bolts (9), flat washers (8), lockwashers (7), and
nuts (6).
(5)
Secure intake line elbow (5) on air inlet pipe (3) with hose clamp (4).
(6)
Connect fitting of cold start aid line (2) on air inlet pipe (3).
(7)
Close air cleaner access door.
2-71
