TM 10-4320-315-10Section III. MAINTENANCE PROCEDURES3-4 Introduction. This section contains instructions covering maintenance functions for the operator on the pumpingassembly Personnel required are listed only if the task requires more than one. After completing each maintenanceprocedure, perform operational check to be sure that equipment is operating correctly.3-5. MAINTENANCE OF BATTERYThis task covers: InspectINITIALSETUPGeneralSafetyInstructionsMaterials/PartsDistilled Water (Item 11, Appendix D)WARNINGWire Brush (Item 2, Appendix D)Do not smoke while servicing batteries.Explosive gases are emitted from batteries inoperation Ignition of these gases can causesevere personal injury. Wear safety glasses andrubber gloves.EquipmentConditionsPumping assembly is shutdown (para. 2-8).INSPECT. (Figure 3-1)(1)Open battery access door (1).(2)Check cables (2) for loose connections and corrosion. Tighten loose connections. Using wire brush, cleancorrosion from cables as required(3)Remove caps (3) and check fluid level in cells If fluid is not visible in any cell, fill to just below bottom of cap.(4)Close battery access doorFigure 3-1. Pumping Assembly Batteries3-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business