TM 10-4320-315-10 Table 2-5.  Operator Preventive Maintenance Checks and Services - (Cont ) Interval Procedures: Equipment Is Item Item to be Check for and have repaired Not Ready/ No. B D A W M Inspected or adjusted as necessary Available If: 19 • • Wiring Check for loose/disconnected wires and Loose/discon- cable connectors to control panel, nected wire or alternator, starter relay, fuel solenoid cable. shutoff valve, magnetic pickup unit, governor actuator and engine sensors. 20 • • • Fuel Gage Before and during operation, check fuel level.  (Add fuel as necessary.) 21 • • • Engine and a. Inspect ground and engine Any evidence of Pump compartment for evidence of leaks. leaks • • b. Check drain hole of pump bearing housing for water leaks. • c. Check gage connections for pump suction and discharge pressures for leaks. • • d. Check fuel lines and hose connections for leaks. • e. Check drain line on engine sump for oil leaks. • f. Check engine and pump mounting Loose mounting bolts for tightness  Notify unit bolts maintenance if loose or isolators deteriorated 22 • • Pump Check for leaks.  Check for loose or Suction and missing hardware. Discharge Lines 23 • Oil Line Inspect for leaks.  Check fitting for Fitting is loose (Turbo- tightness  Tighten if necessary. and leaks oil. charger Feed) 24 • • Oil Level Check oil level at dipstick.  If low, add oil through filler neck.  Do no add oil unless level is at or below "ADD' level on dipstick Do not fill above "FULL" line. 25 • Cold Start Check cold start aid for tightness of Aid Hose, hose connections, securing clamp, and Bottle, and cable. Cable 2-13