APPENDIX G TORQUE LIMITS

Table G-1. Torque Specifications for Pump Assembly

TM-10-4320-226-14 Water Pumping Assembly Diesel Engine Driven Wheel Mounted 350 Gallons Per Minute (GPM) 275 Foot Head Models: 350 PAW Manual
Page Navigation
316

TM 10-4320-226-14 APPENDIX G TORQUE LIMITS G.1 SCOPE. This appendix lists torque specifications and torquing instructions for specific engine nuts and bolts. G.2 TORQUE SPECIFICATIONS. This application, preloading and torque angles in degrees are listed in table G-1. G.4 ENGINE TORQUING INSTRUCTIONS. Preloading is applied with a torque wrench that is calibrated in foot pounds (ft. lbs) or Newton meters (N • m). Preloading is applied before angle torques. All angle torques listed in table G-1 and table G-2 are accomplished by turning the bolt or nut a specific number of degrees from a zero reference point as shown in figure G-1. Torquing of two or more bolts securing one assembly should be accomplished in an alternating fashion to ensure assembly seating and equal load distribution. For example, if angle torque specified is 30° initial then 30° final, proceed as follows: a. Coat bolt and surface under bolt head with engine oil MIL-L2104C. b. Set bolts squarely to ensure assembly seating. c. Apply specified preload with torque wrench. Figure G-1. Torque Instructions. G-1

Privacy Statement
Press Release
Contact