TM 10-4320-226-14d.Remove two thrust pads (8).e.Remove two studs (9) from rocker bracket (10).6.6.3.2 Repair.Do notDo notuse dry cleaning solvent without proper ventilation and clothing.smoke or use near open flame or excessive heat.Dry cleaningsolvent is potentially dangerous to personnel and property.Clean partsin a well-ventilated area.Avoid inhalation of solvent fumes.Weargoggles and rubber gloves to protect eyes and skin.Wash exposed skinthoroughly.Flash point of solvent is 100°F to 138°F (38°C to 59°C).Failure to obey this warning may result in personal injury or death.a.Clean parts in solvent.b.Inspect bushings (3 and 4) for excessive wear.Replace if defective.c.Inspect studs (7 and 9) for damage.Replace if defective.d.Inspect thrust pads (8) for defects.Replace if defective.6.6.3.3 Assembly.a.Installb.Installc.InstallOil holesobey thisd.Installe.Installtwo studs (9) in rocker bracket (10).two thrust pad (8).two studs (7) and lock nuts (6).in bushing must align with oil holes in rocker arm.Failure towarning may causepress bushing (4)two bushings (3),equipment damage.in each rocker arm (5).rocker arms (5), washers (2), and nuts (1).6-18
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
