- KEY-
TESTS:
1. FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD TEMPERATURES BELOW-10 (-23 ).
F
C
Remove lubricants prescribed in the key for temperatures above -10 (-23 ). Clean parts with SOLVENT, dry-
F
C
clasping, lubricate with lubricants specified in the key for temperatures as below -10 (-23 ).
F
C
2. OIL FILTER. After installing new filter element, fill crankcase, operate engine 5 minutes, check housing for
leaks, check crankcase oil level and bring to full mark.
3. PUMP SEAL GREASE CUP. To fill cup turn wing nut clockwise to cap, remove cap, fill cup, replace cap and
turn wing nut counterclockwise to top of shaft.
4. OIL CAN POINTS. Every 50 hours clean and lightly coat throttle linkage, leveling jacks and door latches with
OE.
Copy of this Lubrication Order will remain with the equipment at all times; instructions contained herein are
mandatory.
BY ORDER OF THE SECRETARY OF THE ARMY:
BERNARD W. ROGERS
General United States Army
Chief of Staff
OFFICIAL:
J.C. PENNINGTON
Brigadier General, United States Army
The Adjutant General
DISTRIBUTION: To be distributed In accordance with DA Form 12-25A, Operator Maintenance requirements for
Pumps, Fresh Water.
U.S. GOVERNMENT PRINTING OFFICE: 1978 O-264-720
LO 5-4320-215-12
Card 2 of 2
