LO 10-4320-325-12
LUBRICATION ORDER
25 SEPTEMBER 1992
PUMP UNIT, CENTRIFUGAL, DIESEL-DRIVEN,
SELF-PRIMING, 125 GPM WATER, CLASS 3
4320-01-357-1930
Approved for public release; distribution is unlimited.
Reference: TM 10-4320-325-14 and -24P
Intervals (on-condition or hard time) and the related task-
indicate lubrication on both sides of the equipment.
hour times are based on normal operation. The task-
hour time specified is the time you need to do all the
The lowest level of maintenance authorized to lubricate a
services prescribed for a particular interval. On-condition
point is indicated by one of the following symbols as
(OC) oil sample intervals shall be applied unless
appropriate: Operator/crew (C) and Unit Maintenance
changed by the Army Oil Analysis Program (AOAP)
(O).
laboratory.
Change the hard time interval if your
lubricants are contaminated or if you are operating the
Reporting errors and recommending improvements. You
equipment under adverse operating conditions, including
can help improve this manual. If you find any mistakes
longer than-usual operating hours.
The hard time
or if you know of a way to improve the procedures,
interval may be extended during periods of low activity. If
please let us know. Mail you letter of DA Form 2028
extended, adequate preservation precautions must be
(Recommended Changes to Publications and Blank
taken. Hard time intervals will be applied in the event
Forms) direct to: Commander, US Army Aviation and
AOAP laboratory support is not available.
Troop Command, ATTN: AMSTR-MMTS, 4300 Good-
fellow Blvd., St. Louis, MO 63120-1798. A reply will be
Clean parts with dry cleaning solvent conforming to P-D-
furnished to you.
680, SD-2. Dry before lubricating. Dotted arrow points
LUBRICANT INTERVAL
INTERVAL LUBRICANT
TOTAL TASK-HR
TOTAL TASK-HR
D
0.1
100
0.5
Card 1 of 2
