TM  10-4320-344-24 3. Remove   defective   wire   from   wiring   harness. 4. Refer   to   table   D-10   and   cut   wire   from   bulk. Wire   assembly   numbers   in   table D-10   are   for   information   only,   they   are   not   marked   on   wiring   harness,   refer to   terminations   to   determine   what   components   comprise   damaged   wire. 5. Strip   approximately   0.250   (0.635   cm)   inch   of   insulation   from   each   end   of w i r e. 6. Crimp   or   solder   terminal(s)   to   wire. 7 . Install   repaired   wire   in   wiring   harness. Table   D-10. Parts   List   for   Main   Wiring   Harness   Assembly,   Model   US636HCCD-1. Find Part   or Quantity Description NSN Number Identifying   Number Required 1 76930 2 I n s e r t ,     E l e c t r i c al 5935-01-273-7634 Connector 2 MS25036-106 11 Terminal,   Lug 5940-00-283-5280 3 76019 1 Lead,    Electrical, 6150-01-273-7464 Magnetic   Pickup   with Connector 4 MIL-M-5086 AR Lead,    Electrical 6145-01-276-1531 / 1 - 1 4 -2 5 MIL-M-5086 AR Lead,   Electrical 6145-01-237-6926 / 1 - 1 4 -4 6 MIL-M-5086 AR Lead,   Electrical 6145-01-237-9480 / 1 - 1 4 -1 7 MIL-M-5086 AR Lead,    Electrical 6145-01-237-9480 / 1 - 1 4 -0 8 MIL-M-5086 AR Lead,   Electrical / 1 - 1 4 - 7 9 MIL-M-5086 AR Lead,   Electrical 6145-01-237-3990 / 1 - 1 4 - 5 Table   D-11. Main  Wiring  Harness  Wire  Run  List,  Model  US636HCCD-1. Wire   Run Wire Detail Wire Wire   Length Assy Configuration From Terminal To Find Terminal Find   No. Find   No. No. 1 A TB1-1 1 S3-2 1 4 67.00   inches 2 A TB1-2 1 A2-B 1 5 98.00   inches 3 A TB1-3 1 S3-1 1 6 67.00   inches 4 A TB1-4 1 A1-1 1 7 80.00   inches 5 A TB1-5 1 A1-2 1 7 80.00   inches 6 B TB1-6 1 P2-1 3 8 98.00   inches 7 B TB1-7 1 P2-4 3 9 98.00   inches 8 TB1-8 1 M1 9 TB1-9 1 M2 D-20