6-19. CRANKSHAFT (CONT)
Install camshaft and measure axial clearance.
Clearance should be 0.0098 to 0.0236 inch
(0.250 to 0.600 mm). If clearance is not
within specified limits, recheck bearing
bush. Make sure bearing bush bore is within
specified limits and bush is seated properly
in crankcase. Replace in accordance with
paragraph 6-20 if necessary. Recheck bearing
journal on camshaft for wear. Replace if worn
close to camshaft gear. Recheck washer and
camshaft gear for wear. Replace washer or
camshaft if necessary. Recheck axial clear-
ance to see that it is within specified limits.