TM 5-4320-302-14
5-19.
ALTERNATOR (CONT)
Location/Item
Action
Remarks
44. Drive bearing
Install end screws and washers through drive
bearing into bearing support. Tighten alternately
and evenly across drive bearing with socket head
wrench until tightened securely.
45. Spacer
Install on rotor shaft.
46. Compression
Install in voltage regulator/carbon brush holder.
springs and
carbon
brushes
47. Voltage regulator
While depressing carbon brushes, install in bear-
with sealing frame
ing support. Make sure carbon brushes make
and carbon
good contact with slip rings on rotor.
brush holder
5-76